Toyota Highlander Service Manual: Camshaft position sensor (2AZ-FE)love car

REPLACEMENT

HINT: A bolt without a torque specification is shown in the standard bolt chart (see page 03-2 ).

1. REMOVE AIR CLEANER ASSY (See page 14-24 )

2. REMOVE CAMSHAFT POSITION SENSOR

Toyota Highlander Service Manual: Camshaft position sensor (2AZ-FE)love car

(a) Disconnect the sensor connector.

(b) Remove the bolt and sensor.

3. INSTALL CAMSHAFT POSITION SENSOR

(a) Apply a light coat of engine oil to a new O-ring. Install the O-ring onto the sensor.

(b) Install the sensor with the bolt.

Torque: 9.0 NVm (92 kgfVcm, 80 in.Vlbf)

4. INSTALL AIR CLEANER ASSY (See page 14-24 )

    Toyota Highlander Service Manual: Camshaft position sensor (2AZ-FE)love carInspection

    NOTICE: In this section, the terms "cold"and "hot" refer to the temperature of the coils. "Cold" means approximately -10 C (14 F) to 50 C (122 F). "Hot" means approximately 50 C (122 F) to 100 C ...

    Toyota Highlander Service Manual: Camshaft position sensor (2AZ-FE)love carCrankshaft position sensor (2AZ-FE)

    REPLACEMENT HINT: A bolt without a torque specification is shown in the standard bolt chart (see page 03-2 ). 1. REMOVE ENGINE UNDER COVER NO.1 (a) Remove the 6 screws, 2 clips and under cov ...

    More about Toyota Highlander:

    Rear sunshades (if equipped)
    Pull the tab up. Hook the sunshade on to the anchors. To lower the sunshade, pull the tab up slightly to unhook the shade from the anchors, and lower it slowly. Notice To ensure normal operation of the rear sunshades, observe the following precautions. ...

    © 2011-2018 Copyright www.tohighlander.com